The Type 7010 flame detector comprises a polycarbonate enclosure which is mounted by means of an adjustable bracket permitting alignment in both vertical and horizontal planes. The housing fascia and back-box have a high level of ingress protection and are rated at IP66.
Removal of the fascia provides access to terminals and maintenance features. Cable connections are made at two part (plug in) screw terminals, permitting PCB module removal without wiring disconnection.
The unit has open collector transistor type outputs which may be directly used for fire and fault signalling in "Low Power Mode". Alternatively "Relay Mode" may be selected which provides volt free change over contacts.
Sixteen LEDs provide indication of the dynamic status of the eight flame detection channels. These LEDs are principally used as commissioning and maintenance aids. During normal operation, in order to minimise supply current, the indicators are usually disabled by means of PCB jumpers.
Located at the rear of the fascia unit is a six pole SIL program switch for setting the sensitivity level and optical axis focal ‘zoom’ characteristics of the device.

Supply Voltage:-		Detectors:-
Relays Enabled: 20 - 30Vdc		Band Pass : 4.2 to 4.7 um - 8 off
Relays Disabled: 13 - 30Vdc		Long Pass 5.0 to 15 um - 8 off
Supply Current:-		Maximum Range:-
Relays Enabled: <30mA Stand By #		Greater than 100m
Relays Disabled: <20mA #		Angle of View:-
# Maintenance LEDs Disabled		+/- 45 Degrees from axis
Max / Full Alarm: 50 mA ##		Internal Indications:-
## Relays and LEDs Enabled		Flame: Red LEDs - 8 off
Enclosure:-		Ambient: Yellow LEDs - 8 off
Material: Polycarbonate		Maintenance Controls:-
Size: 180x180x90 mm (Ex Bracket)		Reset Push-button
Colour: Grey RAL 7032		Program SIL Switch - Range / Zoom
Ingress Protection Rating: IP66		Timer Periods - Two bit jumpers
Temperature:-		Internal LED Enable Jumpers
-20 to +70 Degrees Centigrade		Relay Mode (Option):-
Weight:-		Alarm Contact : 1 Pole C/O
<1.5 kg - (including bracket)		Fault Contact : 1 Pole C/O
Termination:-		Low Power Mode (Option):-
Two Part Screwed Rising Clamp		Alarm O/P: Open collector norm. off
Max wire size: 4.0 sq mm		Fault O/P: Open collector norm. on

Special Options

The flame detector can be fitted with a screened flexible cable connecting to a seperate junction box. In addition to containing connection terminals, this JB unit can be provided with daylight visible LED indicators illuminating on Fire and/or Fault conditions.